The diagnosis of problems in switchmode power supplies is sometimes made complicated due the interdependence of components that must function properly for any portion of the power supply to begin to work. Depending on design, SMPS may or may not be protected from overload conditions and may fail catastrophically under a heavy load even when supposedly short circuit proof. There is particular stress on the switching devices (they are often 800 V transistors) which can lead to early or unexpected failure. Also, SMPS may fail upon restoration of power after a blackout if there is any kind of power spike since turn-on is a very stressful period - some designs take this into account and limit turn on surge.
However, the cause of many problems are immediately obvious and have simple fixes - the blown chopper transistor or dried up main filter capacitor. Don't assume your problem is complex and convoluted. Most are not. You should not avoid attempting a repair just because there is a slight chance it will be more challenging!
A low power (e.g., 25 W) fine tip soldering iron and fine rosin core solder will be needed if you should need to disconnect any soldered wires (on purpose or by accident) or replace soldered components. A higher power iron or small soldering gun will be needed for dealing with larger components. Never use acid core solder or the type used for sweating copper pipes!
CAUTION: You can easily turn a simple repair (e.g., bad solder connections) into an expensive mess if you use inappropriate soldering equipment and/or lack the soldering skills to go along with it. If in doubt, find someone else to do the soldering or at least practice, practice, practice, soldering and desoldering on a junk circuit board first! See the document: Troubleshooting and Repair of Consumer Electronic Equipment for additional info on soldering and rework techniques.
No comments:
Post a Comment